Service manual

10. Remove the snap fastener from the shield
braid in the Minitmoog.
11. Install the touch sensor bar in the unit and
solder the drain wire to the shield braid of the
interconnecting cable.
12. Mechanically reassemble the touch sensor
bar in the reverse order of disassembly.
NOTE
The drain wire should be positioned to the
left side when reassembling the unit.
V
FIGURE 8-6 TOUCH SENSOR BAR REASSEMBLED
8.3 INSTALLATION OF NEW OR REBUILT
TOUCH SENSOR BAR
1. Remove case.
2. Set unit on rear panel using support blocks.
3. Remove bottom access cover.
4. Compress touch sensor bar by tightening
all adjusting screws.
5. Remove five mounting nuts.
6. Disconnect wiring to touch sensor bar and
dislodge bar from keyboard "L" channel, ensuring
all mounting screws are clear of mounting holes.
7. Slide touch sensor bar out of right side
of unit.
8. Reassemble in reverse order using a new
or rebuilt touch sensor bar.
45