User`s manual

CHAPTER 4.0 Getting Started 4-11
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
4.11 High Power Application
Apply the appropriate 3-phase voltage (230Vac/400Vac) to the DS2110 controller and allow approximately 1.3
seconds for the softstart sequence to complete. If the drive has been set up correctly and all errors removed, the
softstart relay should close to indicate a successful soft start-up.
The “Continuous Bus Voltage” window provides an indication of the “Detected DC Bus Voltage”, ”Over Voltage
Limit” and “Under Voltage Limit”
“DS2110
→ Drive Setup → DC Bus Monitoring → Continuous Voltage”
Figure 4.10 DC Bus Voltages