User`s manual

CHAPTER 4.0 Getting Started 4-15
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
4.15 Oscilloscope
4.15.1 Oscilloscope Set-up
 Open the oscilloscope, “DS2110 → Oscilloscope”
 The Status prompt in the lower right hand corner should be yellow and read “initializing”
 Set-up Channels 1-3, Timebase and Trigger as per the table 1 below,
Figure 4.14 Oscilloscope
Channel 1 Channel 2 Channel 3 Timebase Trigger
Status
Visible Visible Visible ------------ ------------
Source
Demand Velf Iqact ------------ Demand
Scaling
200000000 / div 20 / div 5 A / div 0.002 s / div ------------
Delay
------------ ------------ ------------ ------------ Delay - 0.002 s
Coupling
------------ ------------ ------------ ------------ DC
Slope
------------ ------------ ------------ ------------ Rising
Mode
------------ ------------ ------------ ------------ Single
Table 4.1 Oscilloscope Channel Set-up