User`s manual

CHAPTER 3.0 Wiring and Installation 3-3
CDS7324 (FORMERLY LSF-0819)
Rev. A INSTALLATION & USER’S MANUAL
3.1.4 Serial Set-up Terminal (User-Supplied)
An RS-232 interface should be established for individual servo-drive communications, using a PC. The PC can
run Moog's WinDrive Windows-based user-interface program.
3.1.5 Control-Backup Power Input (User Supplied)
The DS2110 requires a control power source to supply backup-power for the control electronics. This control-
backup power is useful where the user requires that the DS2110 does not lose absolute position data or status
information when AC mains power is removed from the DS2110.
The user is directed to the local Moog sales office or authorised distributor for a recommended list of these control
power source devices.
The 24V
dc
control power option allows high voltage motor power to be removed from a DS2110 Series Servo-
drive without losing control power.
The acceptable voltage range for this supply is 24V
dc
±10% with a minimum current rating of 2A
dc
per DS2110
Series Servo-drive connected. A low cost unregulated DC supply is adequate.
3.1.6 Brushless Servo motors
The DS2110 series Servo-drive is compatible with Moog brushless servomotors.
Normal connection to the motor requires two cables - a power and a signal cable. The power cable provides
three-phase stator power, protective earth and brake connections. The signal cable carries position transducer
feedback signals and motor temperature detection connections.
NOTE - The 24V
dc
power supply must be compliant with the requirements of
the EU EMC Directive. The 24V
dc
output from the power supply must be Safety
Extra Low Voltage (SELV - as defined by European standard EN 60950).
Required for
CE-Compliance
The personal computer using Windrive is a service engineering tool only and
must be installed so that use of the key sequences which allow control of the
machine functions is accessible to authorized, qualified service personnel only.
All such service set-up computers must be CE -marked as compliant with the
EU EMC Directive.
Required for
CE-Compliance
The G362-x003 &-x006 MUST have a 24V
dc
logic backup supply connected for
the drive to operate. No internal high voltage backup is provided on these
smaller models.