User's Manual

CALIBRATION

Calibration allows the Theremini to adapt to its environment and to adjust

to your body movements and playing style. Calibration should be repeated

when setting up in a new location, or whenever the Theremini has been left

unused for a long time. Press the EFFECT button to begin the Calibration

procedure. (A detailed and illustrated guide to the Calibration procedure can

be found in the “Getting Started” section

of this manual.)

NOTE: To skip a calibration step, simply press

the SETUP button while the countdown is in

process. You can also simultaneously press

the SETUP and EFFECT buttons any time to

exit the Calibration procedure.

CALIBRATION & TUNING

Press the SETUP button and step at least

4 feet away from the Theremini. This

will allow the Theremini to adjust to its

environment and tune the oscillators. The

display will count down, and then prompt

you to proceed to the next step.

CV OUT CONTINUED

MODE

Use the PRESETS knob to choose the proper Control Voltage output scaling

to match your analog equipment, either 0~5 Volt or 0~10 Volt. Press the

SETUP button to advance to the next parameter.

APPLY PITCH CORRECTION

Use the PRESETS knob to select whether the current Pitch Correction

setting is applied to the Control Voltage output, or if it is not. Press the

SETUP button to exit the MIDI CV SETUP Menu.

PITCH ANTENNA HIGH NOTE:

Assume your normal playing position.

Press SETUP and stretch out your right

hand close to the Pitch antenna, but

without touching it. This will determine

your hand position for playing the

highest selected note. The display will

count down, and then prompt you to

proceed to the next step.