Operating instructions

Hardware Installation
1. Locate your camera in the IP camera compatibility chart (Appendix A). If your camera is not listed, please contact Moog at (800)-554-1124.
2. Connect the striped I/O Detect wire to the I/O terminal specied for your device.
3. Connect the plain (no stripe) I/O Detect wire to the I/O terminal specied for your device.
4. Connect the power output pin from the IP Reset to the Power input on your device.
5. Connect the power from the transformer to the power input in the IP Reset.
6. Add your device’s conguration to the IP Reset Manager Software or Network video recording (NVR) software (See IP Reset Manager Software
installation in CD-ROM).
Note 1: Connection polarity MUST be observed for all devices.
Note 2: If the input connections need to be modied, the striped wire is plus VDC and the solid wire is ground (0 VDC).
IPRS01 Serial # 001656
Tested to comply
with FCC standards
Vin Vout Alarm
24Vac
Red Red/Black Brown
Orange Orange/Black Black
12Vdc
Red(+) Red/Black(+)
Orange(-) Orange/Black(-)
Camera dome
connection point
IP Reset power box
When you open the power box, you will see the ipulse unit. Plug in
the heater/blower and camera power form the dome into the mating
connector supplied in the PB24RS.
IPRS01 Serial # 001656
Tested to comply
with FCC standards
Vin Vout Alarm
24Vac
Red Red/Black Brown
Orange Orange/Black Black
12Vdc
Red(+) Red/Black(+)
Orange(-) Orange/Black(-)
Black
Blue
Purple
Finally attach the brown and black wire to the blue and purple wire
of the dome. Inside the dome, attach the purple and blue wire to the
alarm output of the camera.
Brown