Specifications

10
THE CLUSTER FLUX FRONT PANEL
DRIVE Control - Sets the input sensitivity of the Cluster Flux. This control
is only active when the Effect is on. The available gain is from -7dB to
+28dB nominal. The Cluster Flux is designed to work with instrument or
line-level signals.
LEVEL LED - Works in conjunction with the DRIVE control. Red indicates
clipping. Yellow indicates the nominal signal level for best signal-to-noise
ratio. Green indicates the presence of signal below the nominal level.
Note: For most instruments, the best approach is to set the DRIVE level so the LEVEL
LED lights up mostly yellow. It is okay to drive the Cluster Flux into clipping/distortion
if that sound is desired. If using an instrument with a wide dynamic range, you may
want to insert a compressor prior to the input of the Cluster Flux for the best signal-
to-noise ratio without clipping.
OUTPUT LEVEL - Sets the strength of the Cluster Flux Output at both the
Left and Right Audio Outputs. This control is only active when the effect
is on. The Output Level control is designed so a boost, attenuation or no
change can be achieved with any Drive setting.
MIX - Sets the blend ratio of dry to wet signal. This control is only active
when the effect is On. Counterclockwise allows only the dry signal to pass
to the Outputs. Clockwise allows only the wet signal to pass to the Outputs.