Service manual

- 10 -
Section VI: Cover Removal and Sub-assembly Replacement
In order to service the Mini-Moog circuitry, it is necessary to remove the rear cover assembly.
CAUTION:
Be sure the unit is unplugged before removing the cover.
Remove 18 screws (5 top, 5 lower back, and 4 each end of cover); then lift the cover off.
Circuit boards are plugged into sockets at the bottom and secured at the top with two mounting
screws. To remove a circuit board, first remove the screws then unplug from the connector.
When replacing, be sure board is firmly seated in the connector before tightening the mounting
screws. Remember to re-install the fiber washers between the boards and the frame.
After board replacement, refer to Section VII: Adjustment Procedures and Locations, to
determine which adjustments should be made.