Operating instructions

 Page38        



 SlimPhattyUser’sManualTheUserInterface        

 Page39



 SlimPhattyUser’sManualTheUserInterface

POT MAPPING (con’t):

Press the CURSOR button once more to select whether the assign-

ment applies to internal only (INT), external only (EXT) or BOTH.

Pressing the CURSOR button again will return you back to the

beginning.

Once programmed, Pot Mapping is enabled in a section by selecting

the active parameter in that section. For example, suppose Pot

Mapping is conﬁgured for the MODULATION knob to send MIDI

CC#10. To activate Pot Mapping in the Modulation section, press the

button that is currently active (i.e. lit) in that section. The button will

turn off (no button in the Modulation group will be illuminated); the

MODULATION knob will now send MIDI CC#10 information when

it is adjusted. To disable Pot Mapping in the Modulation section, simply

press one of the buttons in that section, and the MODULATION

knob will return to its normal function.

Values: MIDI CC assignments: OFF, 0-127

Destination: INT, EXT, BOTH

PERFORMANCETIP:Here’saPotMappingexample:supposeyouhaveanexternalaudiodevice

thatyouwanttocontrolindependentlyoftheSP.YoucouldprogramPotMappingtohavethe

ModulationcontroltransmitMIDICC#XX,butonlyhaveitprogrammedforexternalcontrol(EXT).

Withthissetup,youpresstheactivecontrolintheModsection(eithertheLFORateorAmount

switch)toengagePotMappingwithoutaffectingyourSP’ssoundorstate.Nowwhenyouadjustthe

MODcontrol,itsendsMIDICC#XXouttoyourexternalMIDIdevice,buthasnoeffectontheSP’s

soundengine.