Specifications

TRIGGERS
A trigger/gate sends a signal which turns ON or OFF the Contour Generators of an instrument.
Moog has customarily used S-triggers (switch triggers).
When an S-trigger occurs, the voltage (around 12 volts) goes from +12 to ground. Acting as a switch in the circuit,
this causes the Contour Generators to turn on.
Taurus II also has a V-trigger otherwise known as a gate. A V-trigger occurs when the voltage (at 0 volts)
goes from 0 to +10 volts. Taurus (I will accept input voltages from +3v to +10 volts as V-triggers.
The TRIG IN/OUT connector is a stereo
jack and acts as either an input or output.
Tip is the S-trigger
Ring is the V-trigger/gate
TRIG IN/OUT
TIP
S-TRIG
RING ^ V-TRIG/GATE
The cables required to interface Taurus II with other Moog products are available from Moog's Service Department
at a small cost. Alternatively, you can make up these cables yourself as follows:
CV OUT
TIP
CVIN
RING
43