Operating instructions
The MAC address for each unit can be located
on the Main tab where it shows the units
status. There MAC address can be found in
three separate locations on that screen under
LAN MAC, WAN MAC, and AP MAC. All three
MAC address will be the same.
Encryption for the wireless link is also set
from this page.
Select the Encryption method that is desired
and enter the appropriate encryption key. Note
that this same key will need to be entered in
all devices connecting to the wireless network.
Click the Change button in the bottom right
hand corner to apply the security settings.
Log into each unit, take note of the listed MAC address, and enter it into the WDS Peers box on the other unit.
The default SSID can be changed by clicking in the SSID box, typing in the new SSID that is required, and clicking
on the Change button at the bottom right hand corner of the window.
• Connect to the PB24M24/58 by opening a web browser and connecting to http://192.168.1.100.
Login to the device using videolarm for the
username and camera for the password.
Click on the Network tab on the
conguration page.
Note that a static IP address of 192.168.1.100
has been assigned to the unit be default.
The default IP address, subnet mask, and
gateway can all be changed from this screen
if needed.
Click in the corresponding box and enter in
the required IP setting, then click the Change
button in the bottom right hand corner of
the window.
NOTE - Connection to the PB24M24/58 will be lost if the IP address is changed at this time. A connection will need
to be made to the new IP address that has just been assigned in order to view the conguration page again.
PB24M24/58
4