User Guide

LFO SYNC:
The LFO Sync switch sets the trigger method for starting the LFO waveform.
OFF/SYNC: This setting allows the LFO to be free running, unless there is an input to
the SYNC jack on the back panel. The SYNC jack accepts a +5 V Clock Signal that
retriggers the LFO.
MIDI: Allows a MIDI clock signal to retrigger the start of the LFO cycle.
KB: Allows the LFO to be retriggered when a note on the keyboard is started.
ENV. GATE: Allows a gate input to the ENVELOPE GATE jack on the back panel to
retrigger the LFO.
LFO RATE INPUT:
This jack accepts an expression pedal or control voltage from –5 to +5 Volts. A
positive voltage here adds to the position of the LFO Rate control, a negative
voltage here will subtract from the position of the LFO Rate control.
LFO SYNC INPUT:
This jack accepts a footswitch or +5 V Gate input. Closing the footswitch or
applying a gate here will retrigger the LFO Waveform.
SAMPLE AND HOLD INPUT:
This jack accepts an expression pedal or control voltage from –5 to +5 Volts. The
Voltage here is applied to the Sample and Hold Input.
SAMPLE AND HOLD GATE INPUT:
A +5 Gate signal will trigger the Sample and Hold Circuit.