User Guide

K. THE USER INTERFACE/ VOYAGER SOFTWARE VERSION 2.5
1. The Interface
The interface for the minimoog Voyager’s software functions is in the center of the
instrument (figure 25).
(figure 25)
The display is a LCD screen in the center. When the unit is first powered on, the screen
will read the message:
The message will stay on the screen for approximately 5 seconds, then the screen will
display the current active preset. Note that the LED above the button labeled “PANEL” is
lit. The sound produced will be the last sound used before the Voyager was powered
down previously.
There are three operating modes for the Voyager:
- MASTER: Used for accessing Global settings for the Voyager, and data send and
receive functions.
- EDIT: Used for editing parameters of a preset not accessed through the
front panel. Naming and saving presets is done in EDIT mode.
- PANEL: Used for accessing the Voyager’s presets and performance functions.
The Voyager contains 128 presets.