User Guide

velocity output from the keyboard. Hard requires a harder touch to output higher
velocity values.
4.4 COPYRIGHT INFO/ FACTORY SETUP MENU
Copyright Info, shows the copyright dates, as well as the author of this software, Rudi
Linhard (Thanks, Rudi!). This is the entry page to the Factory Setup menu – simply press
the +1 button to see the Factory Setup Menu. These functions are used for initializing
parameters in the Voyager’s Preset bank. While in the Factory Setup Menu, press
CURSOR, or MASTER to return to the Master Mode Menu. The Factory Setup Menu has
two pages of functions – the each function has a page number and a line number.
Here they are:
1.1 Factory Sounds
The Factory Sounds function is to restore the Voyager to its default factory state.
Performing this function will wipe out any presets in memory and replace them with
the standard Voyager Performer Edition Preset Bank – programmed by Zon Vern
Pyles, so don’t do this unless you are sure you want to. Select “Factory Sounds” and
press ENTER. The screen will prompt: “Reload the Factory Preset Sounds and Default
Functions? Yes/No”. To restore the Voyager’s factory presets select “Yes” and press
ENTER. To escape without restoring the Factory presets, select “No” and press ENTER.
1.2 Master Volume
The Master Volume function is used to invert the stored Master Volume values of
the Voyager’s Presets. This can be useful if you have a bank that has all the Master
Volume parameters stored at 0, by performing this function, the Volume values will
be changed to the Maximum Volume.
1.3 T.S. XYAG Dest.
The T.S. XYAG Destination function is used to restore the default parameters of the
Touch Surface destinations, MIDI CC off/ or number, Direction of control, and
amounts for the X,Y, Area axes as well as the Touch Surface Gate. The Default values
are:
X= Filter Cutoff, MIDI CC = Off, Direction= Normal, TS-X amount 50%
Y = Filter Spacing, MIDI CC = Off, Direction= Normal, TS-X amount 50%
A = Filter Resonance, MIDI CC = Off, Direction= Normal, TS-X amount 50%
Gate = No switch, MIDI CC = 88, Polarity = Normal
To initialize the Voyager’s Touch Surface parameters, select the function “T.S.
XYAG Dest.” and press ENTER. The screen will prompt: “Reset the Touch Surface XYA
& Gate Setup of all Preset Sounds? Yes/No” Select Yes and press ENTER. Press
CURSOR to get back to the Master Mode menu.
1.4 Shaping 1&2
The “Shaping 1&2” function restores the default settings for the Programmable
Mod Buss Shaping Sources. The defaults for both sources are: “fixed value, value =
0”. To restore the default settings for Shaping 1&2 sources, select the function
“Shaping 1&2” and press ENTER. The screen will prompt: “Reset Shaping 1&2
Functions of all Preset Sounds? Yes/No”. Select Yes and press ENTER.
2.1 Clock Divider