User Guide
that axis does not modulate the destination. 50% means that the amount of the
touch surface output adds 50% of the total range of that control to its present
value. For example, if the Filter cutoff is the destination of touch surface x, the
amount is set to 50%, and the Cutoff knob is fully counter clockwise, the
maximum X value (all the way to the right) would make a change in the filter
cutoff equal to turning the Cutoff knob to the mid-position. When the amount is
set to 100%, the touch surface output equals the full range of the destination’s
control.
5.2 T. S. MEMORY MOD BUSS
TOUCH SURFACE MEMORY is for allowing the last known X and Y parameters of the
touch surface to be held in memory after contact is no longer made with the touch
surface. This is for the X and Y signals used as the programmable Sources in the MOD
BUSSES. When this function is off, the X and Y values return to zero after contact with the
touch surface is no longer made.
5.3 T. S. MEMORY GLOBAL
This adds memory to the direct destinations of Touch surface X and Y. When
the user’s finger is removed from the touch surface, the last X and Y values are
remembered until the next time contact is made with the touch surface.
5.4 POT MAPPING SOURCE/DESTINATION
Pot Mapping is a new feature in Version 2.0 software that allows up to 4 different
modulation routings different than the Mod Busses. In the Edit Menu, select Pot
Mapping and press ENTER. The Pot Mapping Menu appears, showing Source and
Destination Maps 1-4. Select a map and press ENTER. The screen now shows a Source
(SRC), a Destination (Dest.), a Direction, and Amount. The CURSOR Button moves
between the different parameters, and the +/- 1 buttons select the values. The
available Pot Mapping Sources are:
Performance Controls:
− Pitch Bend
− Mod. Wheel (Default Source for SRC & DEST Map 3)
− Pressure
− Velocity Attack (Note On Velocity – Default Source for SRC & DEST Map 1)
− Velocity Release (Note Off Velocity)
− Foot Pedal 1 (Mod 1 Input – acts like Mod Wheel for Pedal/On Mod Buss, on if
nothing is plugged into jack – Default Source for SRC & DEST Map 4)
− Foot Pedal 2 (Mod 2 Input – The On/Mod 2 Source of the Mod Busses, On if
nothing is plugged in to this jack)
− Key Pitch – (CV from Keyboard – Default Source for SRC & DEST Map 2)
Front Panel Controls:
− LFO Rate
− Glide Rate
− Mod Wheel Amount
− Pedal Amount
− Osc.1 Octave
− Osc. 1 Wave
− Osc. 2 Frequency
− Osc. 2 Octave
− Osc. 2 Waveform
− Osc. 3 Frequency