User Guide

- Getting Started
- Understanding the VX-351
- Documenting your work
- Using the VX-351 and the minimoog Voyager together
- Adding a moogerfooger® CP-251 to the mix…
- Connecting other CV compatible equipment.
- Technical Information
GETTING STARTED with the VX-351
Important! Please read the instructions before attempting to use the VX-351
with your minimoog Voyager!
1) Inspect the contents of the carton. It should include:
- The VX-351
- A 6’ cable with db-25 connectors on each end.
- An Output adapter – to be installed inside the Voyager. The adapter must be
installed prior to connecting the VX-351.
- An installation guide for the Output adapter.
You will need the following:
- A place close to your Voyager to set your VX-351 – if you have purchased the
optional rack mount kit for the VX-351 you’ll need a 19” equipment rack with 3
available spaces.
- Some ¼” patch cables for connections between the VX-351 and the Voyager –
the more the merrier – choose lengths that are convenient to use with out the
“spaghetti” effect.
1) The first step is installing the VX-351 output adapter. For this procedure refer to the
installation guide. The adapter MUST be installed in these units to ensure proper
operation of the VX-351.
2) Locate the male end (the end with recessed pins) of the DB-25 cable – this is the
end that plugs into the connector on the Voyager’s back panel labeled
“ACCESSORY PORT”. Align the cable properly and make the connection. Use the
thumbscrews to lock the connection. Be careful not to force or cross thread the
thumbscrews in the accessory port’s female threads. Following this, connect the
other end of the cable to the connector on the VX-351 labeled “FROM ACCESSORY
PORT”.