User Guide

41
Osc. 2 Level
Osc. 3 Level
Noise Level
2.3 PGM PEDAL SOURCE
PROGRAMMABLE PEDAL/ON SOURCE is a function that allows the user to program 1 of 8 additional
modulation sources to be used when the SOURCE switch for the Pedal/On Mod Bus is set to NOISE/
PGM. Enter EDIT mode, and use the +1 button to highlight PGM PEDAL SOURCE. Press ENTER and the
following Mod Sources appear:
Noise (default)
Filter ENV
Amplitude ENV
Smoothed Sample and Hold
Oscillator 1
Oscillator 2
Touch Surface X
Touch Surface Y
2.4 PGM PEDAL DEST.
PROGRAMMABLE PEDAL/ON DESTINATION is a function that allows the user to program 1 of 8
additional modulation destinations to be used when the DESTINATION switch for the Pedal/On Mod Bus
is set to LFO RATE/PGM. Enter EDIT mode, and use the +1 button to highlight PGM PEDAL DEST. Press
ENTER and the following Mod Destinations appear:
LFO Rate (default)
Filter Resonance
Filter Spacing
Panorama
Osc. 1 Level
Osc. 2 Level
Osc. 3 Level
Noise Level
3.1 PROGRAMMABLE SHAPING SOURCE 1
3.2 PROGRAMMABLE SHAPING SOURCE 2
On both Mod Busses, the Shaping switches point to “On/PGM” in their full Clockwise position. “PGM”
stands for the programmable shaping sources. There are two programmable shaping sources – both
are combined by the software and shared by both Mod Buss Shaping switches. When either of the
Shaping switches are in the On/PGM position, the Programmable Shaping values stored in memory
are applied to Shape the Mod Buss source. Shaping is like an additional level control for modulation
amount – in the case of a Shaping signal like velocity, the higher the velocity, the more the Mod
Source is let through to the Destination. The Programmable Shapers also allow an offset value to be
applied, added to the Shaper itself.
Using the programmable Shapers is useful for creating presets that respond in complex ways – for
instance – you could assign BOTH key pitch and velocity as your programmable shaping sources. In
this case, the higher and the harder you play, more modulation source is passed to modulate the
destination. Many of the Shaping sources are front panel rotary controls. A possible application using a
front panel control as a shaping source is having the Filter cutoff also control the Modulation amount.
Programmable shapers can make for some highly interesting and interactive presets.
The Possible shaping signals for both Programmable shapers 1 and 2 are:
- Fixed Value
- Pitch Bend Wheel
- Modulation Wheel