Product specifications

34
© 2006 Skier’s Choice, Inc.
Please refer to your stereo owner’s manual for proper
operation instruction.
NOTE: Stereo unit is connected to the STEREO switch
on the dash. The ACC switch must be in the “ON”
position before the stereo can be turned on.
The stereo cannot be turned off by the
remote. The “SRC” button on the stereo unit must be held
down for three seconds to completely turn the stereo off.
Continue to hold the SRC button until display goes blank or
turn off the ACC switch on the dash..
If the face displays “ALL OFF”, your stereo
is in standby mode and drawing battery power which will
drain the battery and may lead to a dead battery.
Stereo
Activating The Cruise System
1.Accelerate the boat up to the desired cruising speed.
2.Engage the EZ Cruise System by moving the rocker
switch from “OFF” to “SET”. At this point the cruise
system will take over throttle control and maintain the
RPM at which it was set. The small red LED light will
come on to let the operator know that the system is
EZ Cruise
engaged. The red LED light will remain on until the
system is turned “OFF” using the rocker switch.
3.The system will not allow any more throttle input than
the position of the throttle arm. Therefore, the throttle
arm should be advanced completely after the initial
engagement of the system to allow the system to
maintain the set RPM with different throttle positions
required such as when the boat turns.
NOTE: If the engine is turned off and the cruise
system is left on, when the engine is restarted, the
operator will have no throttle control, because the
cruise system will engage at the idle RPM.
Adjusting The Boat Speed
1.The speed of the boat can be adjusted faster by pressing
and holding the “+” side of the momentary rocker switch,
which will increase the engine RPMs relative to the
throttle position, therefore to go faster than the initial
set point; the throttle arm must be moved past the
position where the system was engaged. An easy way
to accomplish this is to move the throttle arm all the
way forward after the system is engaged, allowing the
boat to be increased to wide open throttle, if desired,
using the “+” side of the momentary rocker switch.
2.The speed of the boat can be adjusted slower by
pressing and holding the “-” side of the momentary rocker
switch, which will decrease the engine RPMs. The
engine will decrease RPMs below the initial set point.
Disengaging The System
1.The EZ Cruise System will disengage throttle control
when the throttle is brought back below the current RPM
set position at that time. IF the engine RPM has been
changed using the “+” or “-” momentary rocker switch
during operation, the latest RPM position is the point
where the cruise system will disengage throttle control
once the throttle position is lower than that relative RPM
position. The system will reengage once the throttle
position is advanced back above the last set RPM
position, as long as the motor was not turned off.
2.The system can be completely disengaged by turning
the system “OFF” using the rocker switch. If this is
done while the boat is at speed and the system is
engaged, the throttle will have to be moved below the
set RPM position before it will completely disengage
and allow the operator complete throttle control.