Owner`s manual

380D Nēo Series
Remote Control Operation
The Nēo 380D Digital-to-Analog Converter uses the ‘CRM-2’ full-function
remote control (figure 6). It operates on the Philips RC-5 communication
protocol and is can be used with other Simaudio MOON components.
The ‘CRM-2’ remote uses two AA batteries (included). To install them, simply
slide the back plate off in the direction of the arrow; insert the batteries in the
correct direction and then replace the back plate.
To engage the ‘CRM-2’ remote for use with the Nēo 380D, you must first
press the button labeled D/A.
The POWER button located on the upper left will switch the Digital-to-Analog
Converter to either ‘Standby’ or ‘On’ mode.
The DISPLAY button turns the front panel display on and off.
The 2 buttons labelled ◄ INPUT ► allow you to sequentially scroll, either
backwards or forwards, through all eight (8) available inputs. For example, to
switch from “D4” to “D1” you may press either ◄ INPUT three (3) times or
INPUT ► five (5) times. Pressing and holding down either of these buttons
results in only a single change to the selected input.
The MUTE button turns off the output volume. Pressing the “Mute” button a
second time will reinstate the output volume level back to its current setting.
For Nēo 380D’s equipped with the optional volume control:
The 2 buttons labelled ▼ VOL ▲ allow you to control the volume level.
Pressing ▼ VOL results in a decrease in the volume level; Pressing VOL ▲
results in an increase in the volume level. You may either press and hold these
buttons down or press them briefly to make volume adjustments.
NOTE: The buttons labelled ◄ BAL ► don’t affect the operation of the 380D.
Figure 3: CRM-2 Remote Control
.
12