User`s guide

10
DISSASSEMBLY
To dismantle the scooter just reverse the steps for assembly.
*You must power o your scooter before dissassembly.
(1) Turn o the power and take out the power key from switch lock.
(2) Loosen and Remove the seat from the seat post.
(3) Disconnect the turning lights cable and remove the rear fairing.
(4) Disconnect the main battery cable from the controller.
(5) Unplug all battery connections.
(6) Remove the batteries from oor pan.
(7) Disconnect the front chassis cable from the controller.
(8) Fold down the tiller to horizontal.
(9) Pull out the security pins from the positioning holes.
(10) Holding the tiller by one hand and seat post by another, push away
from each other, while swinging both modules slightly up and down.
TRANSPORTATION
Of course, the best way to transport your scooter is when it’s fully assem-
bled to avoid possible mistakes during its installation. e Journey
Series scooters can t most car models. Following the steps below will aid
in the transportation of your scooter.
(1) Place the rear chassis rst into the car trunk. Put it close to one side
and ensure that the clutch is engaged for avoiding possible movement
during the trip.
(2) Place the front chassis across the remaining section of the trunk.
(3) Load the batteries.
(4) Place the seat in a way that the upholstery is protected. In case there is
no room for the seat, place it upside down on the back seat of your car.