User manual

7. Violate a detection zone (open a door, window, etc.). The keypad will
beep continuously and the indicator of the corresponding zone will
light.
8. Secure the zone (close the door, window, etc.). The keypad
beeping will cease.
9. The interior detection devices will also cause the keypad to
beep if
entering those protected areas when testing unless the
INTERIOR is
first turned OFF. You may also want to walk test motion
detection
devices to check whether the pattern is covering the areas
of concern.
10. Begin at step five to test the remaining sensors.
11. Press the Reset (*) key when finished testing.
NOTE
Your system should be regularly tested at least once per week to insure proper
operation. For UL Listed Burglar systems, the Bell Test should be included as part
of the weekly test. Contact your security company representative for complete
instructions on regular system maintenance and testing procedures. If the wall
mounted transformer which powers the system is removed for any reason, test
the system to see if the standby battery is adequately powering the system.
Reconnect the transformer, secure to the wall plate with the restraining tab
machine screw, and test the system again to assure it is receiving AC power.