Operating instructions

SETUP SOFT MENU OPTIONS
The VES has some user options available while playing a
DVD. Some options may already seem familiar since
many home DVD players have similar options. With a
DVD playing, press setup button on the remote control.
You will see a menu for adjusting the VES display. These
options are normally not needed and are preset at the
factory with default settings. However if you would like
to adjust brightness, contrast, tint, or color settings, you
may do so. Use the arrow up and down buttons on the
remote to move the asterisk to the desired item you wish
to adjust. By pressing the left arrow, the item will be
adjusted down or by pressing the right arrow button the
item will be adjusted up. Once these options are at your
desired setting, press the setup button again to clear the
screen.If youwould liketo restore the displayback to the
original factory defined settings, select the DEFAULT
SETTING option and press enter. This should restore the
display to normal.
There are other DVD options that may be accessed while
a DVD is playing. Press the menu button and the display
will show the play menu options as shown in Figure 11.
These options are standard DVD play menu options that
are seen on most home players that meet DVD forum
requirements. Use the arrow buttons to move yellow
highlight to the option you would like to change. Press
enter to select the option and use arrow buttons to
change the option to the desired choice. To clear this
menu, press the menu button again.
There is one DVD menu that is available while the DVD
player is stopped. With a DVD in and playing, press stop
and then press setup button on remote control or front
panel. Usethe right andleft arrowsto movebetween tabs
for language, rating, mark, audio, and aspect. Use the up
and down arrows to move between options within each
tab. To change an item highlighted in blue, press enter.
This should cause the highlight to turn yellow. Again,
using the up/down arrow will cause arrow on the screen
INTRODUCTION 23
1