Operating instructions

NOTE:

•

The headphones will turn off automatically and the

red LED will illuminate for approximately 2 minutes

when the radio or rear audio system is turned off.

•

The rear audio system must be turned ON before

sound can be heard from the headphones.

Volume Control

Rotate the volume control upward to increase the vol-

ume.

Scan Button

Pressing the scan button will automatically find the

audio signal that is transmitted from the VES when the

Rear Seat Audio System and the headphones are on. The

headphone LED will turn green when the channel is

received.

NOTE: When the 9GREEN LED9 is showing the head-

phones are receiving the audio signal. When the 9RED

LED9 is showing the headphones are searching for the

audio signal. If the LED is off when power is on, the

batteries may need to be replaced.

Headphone Battery Service

•

Using a key or similar flat object insert into the slot.

•

Pry upward, towards the top of the headphones onthe

release tab and remove the cover.

•

Replace the batteries and reinstall the cover.

The replacement batteries for the headphones are three

AAA batteries.

General Information

This device complies with part 15 of the FCC Operation

is subject to the following two conditions:

5. This device may not cause harmful interference and

INTRODUCTION 29