Installation Manual

9
b. Strip ½” (13 mm) of insulation off each of the
leads.
c. Crimp or splice the two (2) blue wire leads to
the two RTS wires (red & black). Polarity is
not important. Refer to section 2.1:
Installation
Notes - System Wiring.
9. Wire the SunKeeper as shown in Figure 2. Wiring
may differ slightly depending on the solar module
manufacturer. Terminal locations and the number
of terminals may also differ. Splices may not be
necessary if extra junction terminals are provided.
Refer to the documentation supplied with the solar
module.
10. In the battery box, wire an in-line fuse holder and
fuse to the Battery + cable. Connect the battery
cables to the battery lugs. Refer to section 2.1:
Installation Notes - System Fusing.
11. If a Morningstar RTS is used, secure the RTS
terminal lug to a battery lug.
12. Uncover the solar module and replace the j-box
cover.
2.3 Surface Mounting
CAUTION: To conform to Class 1, Division 2 Group
A,B,C,D hazardous location requirements, the
SunKeeper and wiring must be contained inside an
approved enclosure.