Load Control with Sure Sine Inverter

DIAGRAMS: TS / Inverter

TS Load Control with Inverter

Abstract:

Two diagrams are provided showing how load control can be safely used with inverters. The

rst diagram is applicable to all inverters. The second diagram is applicable to Morningstar

SureSine inverters (and possibly 3rd party inverters with remote ON/OFF contacts). Note

that in these diagrams, the TriStar Load Controller can be replaced with any Morning-

star controller with Load Control functionality.

v01

Technical Documentation

PAGE 1
Te c h n i c a l D o c u m e n t a t i o n DIAGRAMS: TS / Inverter TS Load Control with Inverter v01 Abstract: Two diagrams are provided showing how load control can be safely used with inverters. The first diagram is applicable to all inverters. The second diagram is applicable to Morningstar SureSine inverters (and possibly 3rd party inverters with remote ON/OFF contacts).
PAGE 2
Diagram #1 (applicable with all inverters) TriStar (Load Control Mode) FUSE Battery + Load - Load + Normally Open (N/O) Relay SureSine Inverter Battery - FUSE + GND - 12 Volt + WHITE AC Loads FUSE BLACK GND GND IMPORTANT: This is not intended to be a complete system diagram; fusing, disconnects, and grounding should comply with local electric codes. Notes: • The Inverter cannot be connected directly to the Load +/- terminals of the TriStar Load Controller.
PAGE 3
Diagram #2 (applicable with SI-300) TriStar (Load Control Mode) Battery + Load Load + FUSE SureSine Inverter Battery FUSE + Normally Open (N/O) Relay Remote ON/OFF GND - 12 Volt + WHITE AC Loads FUSE BLACK GND GND IMPORTANT: This is not intended to be a complete system diagram; fusing, disconnects, and grounding should comply with local electric codes. Notes: • The Inverter cannot be connected directly to the Load +/- terminals of the TriStar Load Controller.