SunLight Quick Test

SunLight Quick Test

SunLight Controller Quick Test

Abstract:

This is a quick test procedure intended only to verify the basic charge and load control

functionality of the SunLight controller. This procedure does not fully test the load timer

functionality and its automatic activation/deactivation of the load.

v01

Technical Documentation

PAGE 1
Te c h n i c a l D o c u m e n t a t i o n SunLight Quick Test SunLight Controller Quick Test v01 Abstract: This is a quick test procedure intended only to verify the basic charge and load control functionality of the SunLight controller. This procedure does not fully test the load timer functionality and its automatic activation/deactivation of the load.
PAGE 2
Before you begin: • This is a quick test procedure intended only to verify the basic charge and load control functionality of the SunLight controller. This procedure does not fully test the load timer functionality and its automatic activation/deactivation of the load. Full timer and load functionality is assumed by verification of Step 2. Please refer to the SunLight Field Testing document for detailed testing instructions that cover the controller’s full range of functionality.
PAGE 3
a PV panel placed in full sun to the Solar Input Terminals (Terminals #4 and #3). Be sure to observe correct polarity. Verify that the green charging light illuminates to confirm the controller is receiving power on its solar input connection. There will be an approximate 10 minute transitional delay before the controller registers a daytime state and starts charging the battery. 4) After a delay of 10-15minutes, the controller should be charging the battery.