Product Manual
2. B
ATTERY
V
OLTAGE
I
S
T
OO
H
IGH
a. First check the operating conditions to confirm that the voltage is
higher than specifications. Consider the temperature compensa-
tion of the controller’s PWM setpoint. For example, at 0°C the
controller will regulate at about 15.1 volts (for 12 volt flooded
batteries).
b. Check that the proper battery type (sealed or flooded) has been
selected.
c. Check that all wire connections in the system are correct and tight.
d. Disconnect the PV array and momentarily disconnect the lead
from the
BATTERY
positive terminal. Reconnect the battery ter-
minal and leave the PV array disconnected. The Green charging
light should not be lit. Measure the voltage at the
SOLAR
termi-
nals (with the array still disconnected). If the Green charging light
is on or battery voltage is measured at the
SOLAR
terminals, the
controller may be damaged.
3. L
OAD
N
OT
O
PERATING
P
ROPERLY
a. Press the TEST button to turn the lights on. This will assist in
troubleshooting the problem.
b. Check that the load is turned on. Check that no system fuses are
defective. Check that no system circuit breakers are tripped.
Remember that there are no fuses or circuit breakers inside the
SunLight.
c. Check connections to the load, and other controller and battery
connections. Make sure voltage drops in the system wires are not
too high.
d. Check for proper LED indications on the SunLight. If the red
LOAD DISCONNECT
LED is on, the load has been disconnected
due to low battery voltage. This is generally a normal state when
the load exceeds the PV array output due to weather and other
sunlight conditions.
e. Check the PV array voltage under direct sun, with the array leads
disconnected. The voltage should be close to the expected open
circuit voltage for the panel type used.
f. Visually inspect the PV array and verify that the array is clear of
debris (e.g. leaves, snow, dirt) and that it is oriented correctly for
the installation location (See NOTE pg. 10).
g. Measure the voltage at the controller
BATTERY
terminals. If this
voltage is above the LVD, the load should have power. Press the
test button and then measure the voltage at the controller
LOAD
terminals, and if there is no voltage present, the controller may
be defective.
103E-R2-2/99
14