SunSaver Manual

MORNINGSTAR CORPORATION 21

3.4 Wiring

NOTE: A recommended connection order has been

provided for maximum safety during installation. When

disconnecting, solar input must be removed rst before

disconnecting battery. See caution below.

NOTE: The SunSaver is a negative ground controller.

Any combination of negative connections can be earth

grounded as required. Grounding is recommended, but

not required for correct operation.

NOTE:

To comply with the NEC, the SunSaver must be installed

using wiring methods in accordance with Article 690 of

the latest edition of the National Electric Code, NFPA 70.

NOTE:

The total current draw of all system loads connected to

the SunSaver LOAD terminals cannot exceed the con-

troller’s load current rating.

NOTE:

For mobile applications, be sure to secure all wiring.

Use cable clamps to prevent cables from swaying when

the vehicle is in motion. Unsecured cables create loose

and resistive connections which may lead to excessive

heating and/or re.

WARNING:

EXPLOSION HAZARD - DO NOT DISCONNECT WHILE

CIRCUIT IS LIVE UNLESS AREA IS

KNOWN TO BE NON-HAZARDOUS.

AVERTISSEMENT:

RISQUE D’EXPLOSION. NE PAS DEBRANCHER TANT

QUE LE CIRCUIT EST SOUS TENSION, A MOINS QU’lL

NE S’AGISSE D’UN EMPLACEMENT NON DANGEREUX.

CAUTION: Unit has no battery removal protection.

Disconnecting battery during charging may cause a brief

spike in load voltage (above the 15V regulation limit)

which may damage sensitive equipment.

3 .0