SunLight SL-10L-12V Installation

5
• Because the SunLight is a series controller, the PV current rating
is specified at the PV array’s peak power (Ipp). The SunLight does
NOT short the PV array for regulation, and it is not necessary to
derate the controller for short-circuit current (Isc) as is commonly
done with shunt controllers.
• The rated PV input current and the rated load current can both
be exceeded by 25% for up to 5 minutes. This 25% overload will
reduce the safety margins for surges and will cause heating that
can shorten the life of the controller.
For the reasons noted above, these higher overload ratings
should
NOT be used for routine operation. They are only to note
overload capability for system design purposes.
• The SunLight is designed to operate continuously in 60°C ambi-
ent temperatures. However, do not install the controller near heat
generating sources or in direct sun. This could cause the temper-
ature rating to be exceeded and damage the controller.
• The date of manufacture can be found on the serial number
(bottom of case). The first 4 digits are the year and week.
6.2 P OLARITY P ROTECTION
The SunLight is generally protected from reversed connections,
but the system operator and other equipment will be at risk
when polarities (+ and –) are reversed. Carefully check before
making each connection to be certain the polarity is correct.
6.3 B ROWNOUT P ROTECTION
If battery voltage sags below 8 volts for any reason (such as
pressing TEST in LVD with a weak battery), the microcontroller
may reset. This is to prevent a low voltage condition from
causing the microcontroller to lock-up at an unattended site.
Note that a brownout reset will begin a new start-up sequence
for measuring night length (Refer to Section 7.4).
6.4 I NSTALLATION P ROCEDURE
N OTES :
• The SunLight prevents reverse current leakage at night, so a
blocking diode is not required in the system.
• The connector terminals will accept a maximum wire size of
AWG #10 (up to 5.2 mm
2
). A flathead screwdriver is required.
(Some #10 spade connectors may not fit in this terminal.)