DIAGRAM: TS MPPT RS-485 Bridging to TS PWM

DIAGRAM: TSMPPT 60/TS

TSMPPT 60 Charge + TS Load w/Ethernet Communications

Abstract:

This diagram shows an example system including a TriStar MPPT 60 performing charging

functionality and a TriStar performing Load Control functionality. An EIA-485 network is used

to enable Ethernet communications with the TriStar Load Controller.

v01

Technical Documentation

PAGE 1
Te c h n i c a l D o c u m e n t a t i o n DIAGRAM: TSMPPT 60/TS TSMPPT 60 Charge + TS Load w/Ethernet Communications v01 Abstract: This diagram shows an example system including a TriStar MPPT 60 performing charging functionality and a TriStar performing Load Control functionality. An EIA-485 network is used to enable Ethernet communications with the TriStar Load Controller.
PAGE 2
PV Array TriStar (in load control mode) TriStar MPPT Load + - RSC adapter RS485 RS232 Array + Load - Array - to: 12V supply Ethernet Battery - FUSE to: router or PC Load + FUSE + Battery + - Battery GND IMPORTANT: This is not intended to be a complete system diagram; fusing, disconnects, and grounding should comply with local electric codes. Notes: • 485 Bridging must be enabled in the TriStar MPPT (this can be done with the MSView software).