Installation & Assembly

Moroccan'Mosaic'&'Tile'House'
2804'S.'Highland'Dr.'Las'Vegas,'NV'89109'
(702)'749-8123'
[e-mail]'
Page%2/3%
Moroccan Cement Tile
Installation Instructions
B) Cleaning the Tiles
Recommended products:
Water, 220 grit sandpaper, Hydrogen Peroxide or Oxyclean
MMTH Uses:
220 grit sandpaper with water
1. Wet the tiles with water.
2. If care was taken while installing the tiles, no other stains should exist.
3. If stains are present, soak a cloth in hydrogen peroxide and let sit on the stain
for 15-20 minutes. This will not harm the tiles in any way.
4. If tile require more cleaning, it is acceptable to lightly scrub the tiles with
Oxyclean or use 220 grit sand paper on the area needed only.
Cement tiles must be sealed before grouting.
This will help prevent any staining from the grout and will add to the strength of
an installation. Please see the instructions for sealing on the following page.
C) Grouting
Recommended products:
Any non-sanded grout white or colored
MMTH Uses:
Polyblend Non-Sanded Grout in white or off white
1. Make sure that the sealant is completely dry before grouting.
2. Grout color should be equal to or lighter than the lightest color in the tile; we
recommend that you take a tile with you when choosing the grout color.
3. The grout should be fluid enough to completely fill the joints.
4. Dampen the tile installation with water before grouting.
5. Apply the grout with a rubber float or a rubber squeegee, always moving
diagonally across the joints.
6. It is important that any excess grout be removed with a damp cloth or songe
before it dries. Darker grout can stain the tile, so keeping the tiles clean while
grouting is prudent.