4 Band portable radio with PLL digital tuning 27004 OPERATING INSTRUCTIONS
ILLUSTRATION Telescopic aerial Snooze button Tuning/Time set + / - buttons On/Off switch Volume control Memory button Light Distance Local switch Headphones DC 6 V Radio/Buzzer ○ ○ Alarm button ○ Sleep Mode 1...
CONTROLS - Switches the radio on and off Switches off the alarm (radio or buzzer) when alarm function is activated Switches off the radio before preset sleep time has elapsed SNOOZE - Interrupts the alarm for approximately 5 minutes +/- Tuning/clock set - For setting the clock and alarm time.
CONTROLS Back of the set -Battery compartment -Fold out stand Display • Pressing the MODE button will briefly change the display mode: -When the radio is off, the display indication changes between time and alarm time. -When the radio is on the display changes between radio frequency, time and alarm time. -If no button is pressed within 5 seconds, the display returns to the original indication.
AC MAINS ADAPTOR (SUPPLIED) You can connect the set to the mains using a mains adaptor. Only use a mains adaptor which supplies DC 6 V with the negative pole at the centre pin of the plug ( ). • Check that the mains voltage indicated on the rating plate of the adaptor matches your local mains voltage. • If the mains adaptor is equipped with a voltage selector, set this to the local voltage. • Connect the mains adaptor to the DC 6 V socket of the set and to the wall socket. -The mains supply is switched on.
ALARM Setting the alarm time • • • • Press the MODE button briefly until the display shows the current alarm time. -The alarm indicator flashes on the display. While the alarm time is indicated, press and hold down the MODE button until the alarm time indicator starts flashing. Use the - button to set the hours and the + button to set the minutes. Press the MODE button once more to store the setting.
RADIO Radio reception • • • Switch the radio on and off with the button. -The frequency and the wave band will appear on the display. Select the desired waveband with the BAND SELECTOR switch. Adjust the volume by turning the VOLUME CONTROL. Aerials • • • For FM reception extend the telescopic aerial fully. To improve the reception you can incline and rotate the aerial. If the FM signal received is too strong (in direct vicinity of the transmitter) you can retract the aerial.
Manual tuning • • • Briefly press the + or - button to tune in the corresponding direction in individual steps. If you keep the button depressed, you can rapidly scan large frequency ranges. -When the button is released, auto tuning is automatically selected. If you briefly press one of the + or - buttons, manual tuning is selected. Last station memory • Your unit is provided with the function LAST STATION MEMORY. The station playing when the radio was switched off will automatically be selected.
GENERAL Sleep function • • • Press the SLEEP button briefly. -The unit switches on the radio and the display will show the previous set sleep period. The sleep time can be adjusted from 90 minutes -->10 minutes by pressing the SLEEP button continuously. -After the preset sleep time has elapsed, the radio will switch off automatically. The SLEEP function can be terminated by pressing the ON/OFF button. Key Lock The key lock function is used to prevent accidental operation or changes to the settings.
GENERAL Technical specification Wavebands MW LW SW FM Power output Battery Station memory Adaptor 522 - 1620 kHz 144 - 281 kHz 5.950 - 15.600 MHz 87.5 - 108 MHz 800 mW peak power : 4 x AA batteries (not included) : 2 x AAA batteries (not included) : Model F4 -3537-14 Input power 230v 50Hz Output 6V DC 200mA Warning labels WARNING: to reduce the risk of electric shock, do not expose this appliance to rain or moisture or dripping or splashing.
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, telephone our technical helpline number. TROUBLESHOOTING Problem Cause Solution button does not work Key lock switch is activated Switch off the key lock function No sound Volume is not adjusted. Headphones are connected. Batteries are exhausted. Batteries are incorrectly inserted. Mains adaptor is not securely connected.
GUARANTEE Morphy Richards products are manufactured to internationally accepted quality standards. In addition to your statutory rights, Morphy Richards guarantee your product to be free from manufacturing and component defects for a period of TWO YEARS from date of purchase. If your product proves to be defective within 28 days of purchase, your Morphy Richards dealer from whom the product was purchased will be pleased to replace it free of charge.