75263 rev1 9/3/07 09:04 Page 1 The After Sales Division Morphy Richards Ltd Morphy Richards products are intended for household use only. Morphy Richards has a policy of continuous improvement in product quality and design. The company, therefore reserves the right to change the specification of its models at any time.
75263 rev1 9/3/07 09:04 Page 2 Polar Fleece Heated bedding Please read and keep these instructions Getting the best from your new blanket... Safety first For your safety, the in-built system in this product will automatically shut off the power if it reaches a temperature that is higher than considered comfortable. It will also shut off automatically if any unsafe situation should arise. Washing Instructions Before washing, detach the switch control and lead from the blanket.
75263 rev1 9/3/07 09:04 Page 3 IMPORTANT INSTRUCTIONS PLEASE READ CAREFULLY AND RETAIN FOR FUTURE USE IMPORTANT SAFETY INSTRUCTIONS • Do not crease the appliance by placing items on top of it during storage. All Morphy Richards heated blankets have been manufactured to the highest European standards. This product has been comprehensively tested for all known safety situations, so you can relax in the knowledge that it will provide warmth, comfort and peace of mind.
75263 rev1 9/3/07 09:04 Page 4 Product safety • • Ensure the blanket is used in the manner in which it is intended, either as an overblanket or underblanket as appropriate. If used on an adjustable bed, check the blanket or cord cannot become trapped or rucked. • Ensure the product is correctly fitted to the bed, following the instructions in this booklet. • Do not insert pins or any sharp objects into the blanket. • Do not tuck the heated part of material under the mattress.
75263 rev1 9/3/07 09:04 Page 5 BEFORE USE Before using this appliance ensure that the voltage indicated on the product corresponds with the mains voltage in your home. If you are in any doubt about your supply, ask your electrical dealer or local electricity company. WARNING: Do not attempt to use the blanket with controls other than those supplied with the unit as referred to on the rating label attached to the blanket.
75263 rev1 9/3/07 09:04 Page 6 Fitting instructions • Use only as an underblanket and do not use above the occupant of the bed. • This product can be used with any type of bedding including waterproof bed protectors. • WARNING: Ensure the blanket is not folded, rucked or creased. When in use do not cover with pillows.
5263 rev1 9/3/07 09:04 Page 7 ⁄ ¤ ‡ fl ‹B ‹A › fi FEATURES ⁄ LCD screen with back light. ¤ Standby/ON LED. ‹ A Down Arrow B Up Arrow › Slider switch OFF, ON, SLEEP TIMER fi Boost button.
75263 rev1 9/3/07 09:04 Page 8 HOW TO USE All night use (manual) 1 Ensure the blanket is fitted to NOTE: Blankets are perfectly safe to be used all night. However we recommend using the heat setting below. the bed correctly. Move the slider switch to the ‘OFF’ position. 2 Plug the power lead into the closest socket, using an extension lead if needed to ensure that the lead is not stretched. Start up 1 Select the ‘ON’ position 2 Using the up and down buttons, select your desired heat level (14).
75263 rev1 9/3/07 09:04 Page 9 Setting the timer 1 Move the slider to timer position. F G 2 The start and timer symbols will appear plus the hour will flash. Use the up and down buttons to select the required start time ensuring its on the correct AM or PM. When desired hour is selected press mode button F. 3 Then the minutes will start to flash, select the desired start time (this setting adjusts in 15 minute steps) When selected press mode button. 4 Timer and finish will appear.
75263 rev1 9/3/07 09:04 Page 10 WASHING INSTRUCTIONS Hand washing 1 Unplug the blanket from the power socket. WARNING: 2 Disconnect the control switch • Do NOT dry clean - • Do NOT iron - and cord from the blanket by lifting the locking lever over the raised button and pull apart. WARNING: Before washing ensure that you detach all the controls from the blanket. 1 Measure the blanket so it can be stretched back to its original size whilst wet.
75263 rev1 9/3/07 09:04 Page 11 After sales servicing HELPLINE Examine the blanket and cord frequently for signs of wear or damage. In the case of damage do not use. If the blanket fails to operate, check the following: If you have any difficulty with your appliance, do not hesitate to call us. We are more likely to be able to help than the store from where you bought it. 1 Ensure that the plug and socket have not become disconnected.
75263 rev1 9/3/07 09:04 Page 12 YOUR THREE YEAR GUARANTEE It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the rating label attached to the blanket and back of the switch.