Specifications

5
Operating the appliance
• On the four slice models, the toaster
has two sides with controls
repeated for each half. Each half
can be used together or
independently.
1 Select the desired level of browning
on the browning control dial fl.
2 After selecting the desired level,
place your bread in the slots ⁄ and
depress the bread carriage lever
downwards until it locks.
3 After the set time has been reached
the bread will pop up automatically
ready for removal from the slots.
The bread carriage lever will have
returned to its upper position and
the heating element will have
switched off.
WARNING: Do not wrap the
cable around the main body of
the appliance during or after
use.
ADDITIONAL FEATURES
Using the re-heat
button
If your toast has popped up and
gone cold, the toaster offers a re-
heat facility. To use, depress the
relevant bread carriage lever and
press the re-heat button ›
immediately. The button will
illuminate and the toaster will
operate for a short period re-heating
the bread.
Using the frozen
button
To toast frozen bread do not adjust
the browning control from your
normal setting. Place the bread in
the bread slots as normal, and
press the frozen button ‹.
Using the cancel button
(Depends upon model)
If you wish to interrupt the toasting
process, press the cancel button fi.
Using the pause and
check/cancel button
(Depends upon model)
If you wish to check the process of
the toasting cycle, press the Pause
and check/cancel button fi. On
pressing the button, the bread
carriage will pop up automatically for
you to check. This action will pause
the heating elements, during this
period the function button lights will
flash. If you have achieved the
desired level of browning remove the
toast from the toaster. If longer
toasting is required, depress the
bread carriage lever within five
seconds to resume the toasting
cycle at the same stage it was at
when it was paused.
Hints and tips
• In order to achieve uniform
browning, we recommend you wait
a minimum of 30 seconds between
each toasting, so that the control
can be automatically reset.
• If toasting one slice only, you may
need to adjust the browning control
to a slightly lower setting.
• Note you will also notice a slight
variation in toast colour on one side
of a single slice.
• Stale bread toasts more rapidly than
fresh bread. Therefore, the browning
control should be set at a lower
setting than usual.
• All sorts of bread can be used as
well as teacakes, small rolls etc.
Slices should not however be so
thick as to cause burning or
jamming within the bread slots.
• If the bread in your toaster becomes
jammed disconnect your toaster at
the socket, allow it to cool, then
remove the bread.
• When toasting 2 or more slices it is
recommended they are of equal size
and freshness.
• Allow the toaster to cool fully before
putting away.
g
TT44068MEE-Rev2-Q7:9225 47507 MEE pump - Jon 9/9/08 13:56 Page 5