47155 rev3_Layout 1 02/09/2011 13:52 Page 1 CM47155 MUK Rev 3 * Upon registration with Morphy Richards (UK & ROI only) Espresso Automatic 47155 For competitions, product hints and tips and more join us at www.homeofthehouseproud.com www.facebook.com/morphyrichardsuk www.twitter.com/loveyourmorphy * Register online for your 2 year guarantee. See back of this instruction book for details.
47155 rev3_Layout 1 02/09/2011 13:52 Page 2 Product overview 1 2 4 3 5 6 7 11 8 9 12 14 10 15 16 12 13 17 18 Features 2 (1) Warming Plate (2) Steam Control (3) Steam Wand (4) Brewing Head (5) Water Tank (6) One Cup Switch (7) Two Cup Switch (8) Coffee or Hot Water/Steam Switch (9) Temperature Indicator Light (10) On/Off Switch (11) Drip Tray (12) Drip Tray Adjustment Button (13) Drip Tray Level Indicator (14) One Cup/E.S.
47155 rev3_Layout 1 02/09/2011 13:52 Page 3 Using your coffee maker 1 Fill the Water Tank (5) and place into the coffee maker. 2 Ensure the On/Off Switch (10),and Steam Control (2) are set to /Off. Select Coffee (8). 4 3 Place the relevant Filter (14) or (15) into the Filter Holder (16). Fill with espresso coffee and tamp with Tamping Spoon (18), or use an E.S.E. pod. Plug the coffee maker into the mains.
7155 rev3_Layout 1 02/09/2011 13:52 Page 4 Using the Steam Wand to froth milk 2 1 Fill the Water Tank (5) and place into the coffee maker. Ensure the On/Off Switch (10),and Steam Control (2) are set to Off. Select Steam (8). 4 3 Plug the coffee maker into the mains. Slide the On/Off Switch (10) to On. The Temperature Indicator Light (9) will stop flashing when the coffee maker is ready. 5 Place the Steam Wand (3) 10mm deep into a jug of milk. Turn the Steam Control (2) to On.
47155 rev3_Layout 1 02/09/2011 13:52 Page 5 Using the Steam Wand to dispense hot water 4 Slide the On/Off Switch (10) to On. The Temperature Indicator Light (9) will stop flashing when the coffee maker is ready. Follow steps 1,2,3 of ‘Using your coffee maker’ on page 3. Then refer to the following. 5 6 Place an empty mug under the Steam Wand (3). Turn the Steam Control (2) to On to start dispensing hot water.
47155 rev3_Layout 1 02/09/2011 13:52 Page 6 Adjusting the height of the Drip Tray Temperature Indicator Light The Temperature Indicator Light (9) flashes slowly when the boiler is heating, this is normal. You can adjust the height of the Drip Tray to reduce splashing when dispensing coffee into smaller cups such as espresso cups. The Temperature Indicator Light will flash fast and the coffee maker will not work when there is a problem.
47155 rev3_Layout 1 02/09/2011 13:52 Page 7 Care and cleaning Descaling 1 Disconnect the appliance from the mains supply. 1 Disconnect the appliance from the mains supply. 2 Make sure the appliance has completely cooled down. 2 Make sure the appliance has cooled down completely. 3 Simply wipe the Steam Wand (3) and exterior with a clean, damp cloth. 3 Remove the Water Tank (5) and Drip Tray (11) from the machine.
47155 rev3_Layout 1 02/09/2011 13:52 Page 8 Troubleshooting Problem Reason Solution • Water is dispensing from the Steam Wand • Steam Control is open • Rotate the Steam Control so its closed • The coffee temperature is too cold • Heater block is not hot enough before dispensing • Before dispensing Coffee, make sure the ready light is illuminated • The coffee grinds are wet after use • Coffee is not compact enough • Tamp the coffee before inserting • Espresso is weak • Wrong coffee type • Alwa
47155 rev3_Layout 1 02/09/2011 13:52 Page 9 Notes 9
47155 rev3_Layout 1 02/09/2011 13:52 Page 10 Notes 10
47155 rev3_Layout 1 02/09/2011 13:52 Page 11 Health and Safety • Do not use the coffee maker for anything other than its intended purpose. Mains cable The use of any electrical appliance requires the following common sense safety rules. • The mains cable should reach without straining from the socket. Primarily there is danger of injury or death and secondly the danger of damage to the appliance.
47155 rev3_Layout 1 02/09/2011 13:52 Page 12 CM47155 MUK Rev 3 09/11 Registering your 2 year guarantee Exclusions Your standard one year guarantee is extended for an additional 12 months when you register the product within 28 days of purchase with Morphy Richards. If you do not register the product with Morphy Richards within 28 days, your product is guaranteed for 1 year. To validate your 2 year guarantee register with us online at www.morphyrichards.co.