Specifications

ENG

1.0 Installing your Morsø stove

1.1 Unpacking the stove

1410: After removing the outer packaging, ﬂatten it and lay onto the ﬂoor close to the stove;

this can then act as protective work surface during the assembly process.

Next, remove the legs from inside the stove. Carefully lift the stove from the wooden pallet and

gently lay the stove onto its back and unscrew the heat shield from the underside of the stove.

Now screw the legs and the Heat shield into position on the underside of the base. Following the

removal of the wooden packaging the heat shield must be ﬁtted to the underside of the stove

at the same time as the legs utilising the same ﬁxing bolts. Please see drawing.

The stove should now be lifted and moved into the upright position, avoiding excess load on

the back legs.

1440: Carefully lift the stove from the wooden pallet and set it carefully in place.

We recommend that two people perform the assembly and installation procedure. The Morsø

1410 weighs 75 kg, while the Morsø 1440 weighs 90 kg.

1.2 Installing the stove

The stove and chimney installations MUST comply to all current National and Local Building

Reg ulations. Boat installations should comply with the recommendations given in BSI Standards

Publication BS8511:2010; your approved Morsø dealer or your local building control ofﬁcer

can advise regarding this. Ultimately, it is you and your installer who is responsible that the

installation complies.

1.3 Chimney sweep

It may also be wise to consult your local chimney sweep before installing the stove. After your

stove has been installed, it is advisable to have the chimney checked and swept at least once

a year. In any case, if your chimney has not been used for some time, it should be inspected for

cracking, bird nests, etc. before it is put back into use.

1.4 Stove placement/clearance requirements

Clearance requirements apply only if the stove is placed near to combustible materials. Per-

mitted clearances to combustible materials are also indicated on the data plate on the rear of

the stove.