Operating instructions

14
3.0 MAINTENANCE
When perfoming maintenance on your stove, always protect yourself, using safety goggles
and gloves.
3.1 Exterior Maintenance
The stove surface is painted with heat-resistant Senotherm paint. It is best kept clean by vacuuming
with a soft brush attachment or by wiping with a lint-free cloth.
Over a period of time, the painted surface may become slightly grey. A can of Morsø touch-up
spray paint should be available from your stove supplier. This can be applied - in accordance
with the instructions - in just a few minutes. When first firing after touching up, the stove will
give off a slight smell as the paint cures. Make sure to ventilate the room well during this phase.
3.2 Internal maintenance
Glass
If the stove is generally run at the correct temperatures, there should be little or no dirt on the
glass. If dirt does settle during lighting, most will burn off as temperatures increase.For heavier
deposits that will not burn off, use morsø glass cleaner, applied when the glass is cold, in
accordance with the instructions. Never use abrasive cleaners on the glass surface.
Reasons for dirty glass
· Fuel too wet
· Logs too large or not split
· Combustion temperatures too low
Replace broken glass immediately.
Do not operate your stove if the glass in the door is damaged.
If you need to replace the glass, it should be replaced with the high temperature ceramic class
supplied by Morsø, contact your Morsø dealer.
Installing the glass
Never install the glass when the stove is in function.
Ceramic glass replacement
Ceramic glass cannot be recycled because
it has a higher melting point that ordinary
glass. If ceramic glass is mixed with ordi-
nary glass, the raw material is spoiled, and
the reclaiming process may be halted. Take
care that the ovenproof glass does not end
up among ordinary recycled waste. That will
be a great benefit to the environment.
Note: Should be handed in to a recycling
station as ceramic glass.
1. Lift the door off its hinges an place face-
down on a sheet of cardboards or other
non-abrasieve fabric.
Revisions
Rev.
Sign.:
Title:
Drawing no.:
1:1
1410 NA
Morsø 1400
RSV
28.04.2010
A2
Exploded Diagram
Date of print: 28-04-2010
U:\udv\Tegninger\1400\1400 Samlingstegning.SLDASM
1400-347 a
-
Itemno.:
This drawing is Morsø Jernstøberi A/S' property and must not be sold, lended or copied without any written authorization from the company.
Material:
Weight:
Model no.
Drawingtype:
Location of file:
Scale:
Format:
Released:
Construction:
Date: