Instructions

DK ENG

4.0 Alternative fuel types

Your new Morsø stove is EN-approved for burning wood.

However, the stove is capable of burning other solid fuels as manufactured smokeless coal

or good quality anthracite (stove nuts). If you re your stove with any fuel other than wood,

it may help to use coal insert/fuel economisers (available for most models), which simply t

into the left and right sides of the rebox. Designed primarily to guide the solid fuel over the

grate area they also slightly reduce the rebox capacity allowing you to have smaller res.

This is an additional accessory and can be purchased from your authorised Morsø dealer.

BITUMINOUS HOUSE COAL SHOULD NEVER BE USED IN YOUR STOVE.

Lighting with solid fuel:

Install the coal insert (where available) into the left and right sides of the rebox.

All stove models are supplied with 1 front grate bar, however in the case of the 1400 series

an optional second front grate bar can be purchased from your Authorised Morsø Dealer. A

second front grate bar will allow for a deeper re bed and a longer burn time.

IN ALL MODELS NEVER LOAD THE FUEL ABOVE THE FRONT GRATE BAR LEVEL.

All air vents must be fully open during the lighting process.

Start by placing 5-10 crumpled sheets of newspaper or 2 Morsø relighters on the grate of

the stove; then carefully spread approximately 1 kg of well-dried kindling on the top. Light

the paper/relighters. Once the kindling has fully ignited, gradually add a small quantity of

solid fuel, adding a little bit more once it has ignited. Continue in this manner until the entire

grate is covered with glowing coals. The level of fuel in the stove should never exceed the

level of the front grate(s). Once the bottom half of the fuel bed is glowing, you should partly

close the bottom vent (on the door). Once the stove has reached your desired temperature

you can maintain the output by opening further for more heat or closing for less heat. The

top air regulator must always be open just enough so that the ames burn almost clearly

and the ceramic glass window stays clean.

Note: In cases where smokeless fuels containing petrocoke are burned, a pale greyish

layer may be deposited on the inner glass surface when the stove is lit. Fuels contain-

ing a high content petrocoke may cause a glistening in the surface of the ceramic glass.

Although visible, the structure of the glass will remain intact and the stove safe. Glass

is not covered by the manufacturer’s 10-year guarantee.