User's Manual

Caution(s)

• To prevent possible damage to the device, do not use sharp or hard objects to depress buttons, only use

fingertips.

• Do not attempt to clean the device or patient cables by submersing into a liquid, autoclaving, or steam cleaning

as this may damage equipment or reduce its usable life. Use of unspecified cleaning/disinfecting agents, failure

to follow recommended procedures, or contact with unspecified materials could result in increased risk of harm

to users, patients and bystanders, or damage to the device. Do not sterilize the device or patient cables with

Ethylene Oxide (EtO) gas. Refer to section 3 for proper cleaning and disinfection instructions.

• No user-serviceable parts are inside. Damaged or suspected inoperative equipment must be immediately

removed from use and must be checked/repaired by qualified service personnel prior to continued use.

• This device is not recommended for use in the presence of imaging equipment such as Magnetic Resonance

Imaging (MRI) and Computed Tomography (CT) devices, etc.

• The following equipment may cause interference with the RF channel: microwave ovens, diathermy units with

LANs (spread spectrum), amateur radios, and government radar.

• When necessary, dispose of the device, its components and accessories and/or packing materials in accordance

with local regulations.

• To prevent possible damage to the device during transport and storage (while in original packaging) the

following environmental conditions must be adhered to:

Ambient Temperature Range: -20°C to 65°C (-4°F to 149°F)

Relative Humidity Range: 5% to 95% (non-condensing)

Atmosphere Pressure: 500 hPa to 1060 hPa

• This device is intended to be used in a hospital or doctor’s office setting, and should be used and stored

according to the environmental conditions specified below:

Ambient Temperature Range: 0°C to 45°C (32°F to 113°F)

Relative Humidity Range: 5% to 95% (non-condensing)

Atmosphere Pressure: 500 hPa to 1060 hPa