User Manual

MADE IN ITALY
language
GE SX-10000 KTDM
Pag 3Pag 3 01/2017
automatiC Control PanEl
• Controller InteliNano Plus
• Controller supply switch
• Battery charge warning light fault
• Emergency stop buttom
• TCM 35 remote control plug
• PAC (ATS) plug
• Battery charger
• Circuit breaker - ELCB-GFI (Ground Fault Interruptor)
• Circuit breaker for 230V 16A sockets
• Output sockets : 1x 230V 32A 2P+T
1x 230V 16A 2P+T
1x 230V 16A Schuko
• Earth terminal (PE)
INTELINANO PLUS CONTROLLER CHARACTERISTICS
Operating mode
• MAN.- AUTO
Display
• Graphic back-light LCD display 128x64 pixels
LEDs
• Engine operation
• AUTO operating mode
• Alarm
Buttons
• START button
• STOP button
• AUTO button
• N° 2 buttons for controller programming
Generator Measures
• Voltage : L1-L2
• Current : I1
• Powers : kVA
• Frequency
Engine Measures
• Water temperature (optional)
• Oil pressure (optional)
• Fuel level
• Rpm meter
• Battery voltage
• Maintance
• Hours meter
Generator Protections
• Short circuit
• Over-Udervoltage
• Over-Uderfrequency
• Phase sequence
Engine Protections
• Overspeed
• High water temperature warning
• Low oil pressure warning
• Low fuel level warning
• Under battery voltage
• Battery charge alternator failure
• Start failure
• Stop failure
• Emergency stop
AMF functins (Automatic control
panel only)
• Measure mains voltage : L1-L2 / L2-L3 / L3-
L1 - N-L1 / N-L2 / N-L3
• Measure mains frequency
• Three phase detection
• Over-Under mains voltage
• Over-Under mains frequency
• Phase sequence
Features • Event log and alarms (10 events)
• Operator interface with icons, no text
• Remote Start and Stop
• Pre-heating
• Fully programmable from the panel or from PC
• Direct connection to engines with ECU via Can
bus J1939
• Manual operation (MRS) with remote start
• IP65 protection
• Operation temperature: -20°C / +70°C
Communication
• Setup USB port
• CAN BUS interface (J1939 only)