Product Manual
SAFETY RULES
M
2-5.1
REV.0-10/13
I
GB
F
• Before raising the mast extract the outriggers loca-
ted at the sides of the machine. Acting on the ou-
triggers level the lighting tower making use of the
bubble, so as to bring the equipment in a horizontal
position. Make sure that the tower rests securely on
the outriggers. If the lighting tower is mounted on
road trailer pull the handbrake.
• Do not operate the lighting tower if the wind speed
exceeds the safe speed indicated or if it is expected
the arrival of storms or thunderstorms in the area.
• Lower the telescopic mast when the tower is not
used.
• Connect the machine to an earthing system accor-
ding to the regulations in force at the place of instal-
lation. Use the ground terminal on the front of the
machine.
• Do not use the lighting tower with wet or damp han-
ds and / or clothing.
• Use plugs suitable for the output sockets of the
machine and make sure that electrical cords are in
good condition.
• The machine must always be positioned so that
the exhaust gases are dispersed in the air without
being inhaled by people or living beings.
• If you use the machine indoors is necessary that
the installation is designed and built by skilled tech-
nicians in a workmanlike manner.
• During normal operation, keep doors closed. The
access to the internal parts should be allowed only
for maintenance reasons.
• Do not place objects or obstructions in the vicinity
of the air intakes and air outlets, a possible overhe-
ating of the generator could cause a re.
• Keep area near to the mufer free from objects such
as rags, paper, cardboard. The high temperature of
the mufer could cause the burning of objects and
cause re.
• Do not touch and do not place objects on the lamps
during operation or immediately after use. The lam-
ps become very hot.
• Do not turn on the lamps without the protective
glass or with the same broken or damaged.
• Immediately stop the machine in case of malfun-
ction.
Do not restart the machine without rst having
found and xed the problem.
SAFETY PRECAUTIONS DURING MAINTENANCE
• Make use of qualied personnel to carry out main-
tenance and troubleshooting.
• It is mandatory to stop the engine before performing
any maintenance on the machine.
•
Always use protective devices and suitable equip-
ment.
•
Always cut off power to the lamps and wait for their
cooling before performing any maintenance or re-
placement.
• Do not touch the engine, the exhaust pipes and the
mufer during operation or immediately after. Allow
the engine to cool before performing any operation.
• With the machine running pay attention to moving
parts such as fans, belts, pulleys.
• Do not remove the protections and the safety devi-
ces unless absolutely necessary, restore them after
completion of the maintenance or repair.
• Do not refuel while the engine is running or hot. Do
not smoke or use naked ames when refueling.
• Refuel only outdoors or in well ventilated areas.
• Avoid spilling fuel, especially on the engine. Clean
and dry any leaks before restarting the machine.
• Slowly unscrew the cap of the fuel tank and put it
back always after refueling.
• Do not ll the tank completely to allow for expansion
of the fuel inside.
• Do not remove the radiator cap when the engine is
running or still hot, the coolant may spurt out and
cause serious burns.
• Do not handle the battery without the use of protec-
tive gloves, the battery uid contains sulfuric acid,
which is very corrosive and dangerous.
• Do not smoke, avoid any naked ames or sparks
near the battery, the vapors exhaled could cause
the battery to explode
18/10/13 M2-5GB_TF