User's Manual

remote control for 3 seconds, the red light of the remote control will flash and
beeps twice. Zone "2" is set successfully. The button “2 ” can arm/disarm alarm
unit "2" installed at Zone 2.
6. Remark
1).Every step of button operation must be completed within 5 seconds.
2 ).When you enter the password wrongly for 5 times, MH107 sounds a
2-second beep and 10 beeps, and the keypad will be locked for 5 minutes.
After that time, you can use the remote control to unlock the keypad and
re-enter the password.
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
CAUTION:
Changes or Modifications not expressly approved by the party responsible
could void the user’s authority to operate this device.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.