User's Manual

5. Quick Setup Guide 5-2

configured to an open IP address within the same subnet. For the default Moseley

configuration, the IP address of the PC must be 192.168.1.x (where x=a value in the

range 1-100). DHCP can also be used to set the PC’s IP address if a DHCP server is

configured on the same subnet. For additional instructions on adding an IP address on

your PC, please review http://www.itsyourip.com/networking/how-to-add-multiple-ip-

address-in-windows-2000xp2003/.

5.2.2 Default

IP Address

The system is configured and tested at the factory using these default values:

Parameter

Value

IP Address 192.168.1.1xx

Netmask 255.255.255.0

Gateway 192.168.1.1

Where: xx=a value in the range 01-99. The IP address is indicated on the back panel as

shown in the following illustration.

Figure 5-2. IP Address Label Location

After configuring the PC network interface, launch a web browser and enter the following

URL (or as specified on the back panel) in the address bar to access the unit’s Web

Interface, e.g. http://192.168.0.101/

5.2.3 Default User Name/Password

A dialog box will request a user name and password. The default values are:

Table 5-1. Default User Names & Passwords

User Level User Name Password

Monitor monitor monitor

Operator operator col1ma

Administrator

administrator

d1scovery

Integrator integrator p1nacate

5.3 IP Address Configuration

1) The PC’s network configuration must be set with the parameters provided at

paragraph 5.2.1.

2) The EVENT 5800 should be accessible from your PC at the default IP address provided

at paragraph 5.2.2. A network ping can be performed to verify connectivity to EVENT

5800.

3) Start a web browser and use the EVENT 5800 default IP address as the URL.

4) Log in at the login prompt. The user name and password are provided in paragraph

5.2.3.

5) The Web Interface includes a navigation menu in the left frame. If this navigation

menu is not visible, make sure the Java environment is properly installed and active.