User's Manual

5. Quick Setup Guide 5-3
© 2012 Moseley, Inc. All Rights Reserved. 602-16620-01, Rev. A
6) In the navigation panel, select: Administration->Network Configuration->General
Network Configuration. The IP address, IP Netmask, and IP Gateway are shown.
7) Enter the new IP address, IP Netmask, and IP Gateway. Click Update to change the
values.
8) To verify the new IP address, change the PC's network configuration to be on the
same subnet as the new IP address set in the unit and a network ping may be
performed to the new address.
9) To continue using the Web Interface, point the web browser to the new IP address.
5.4 Link Configuration
The EVENT 5800 has been set up at the factory and is usable “out of the box”. If
needed, you can change the configuration using the Web Interface as follows:
1) To start the Web Interface, open a web browser and use the EVENT 5800 IP address
(192.168.1.1xx or what you assigned) as the URL and log in when prompted.
2) In the navigation panel, select: Link Configuration->Radio Link->Link Configuration
Link.
3) Select the operating mode. If the EVENT 5800 has one modem installed, select
Standard. If the EVENT 5800 has two modems installed, select 1+1 diversity or 1+1
non-diversity for a protected link.
4) Follow the instructions provided by the link configuration wizard to enter the rest of
the required settings. The “IDU Operational Mode” can be decoded as follows:
rrrAmmmWn[T|E]<mod><BW><TC>
where
rrr = ASI rate in Mbps {000-150}*
“A” indicates ASI