User's Manual
Table Of Contents
- 1.Safety Precautions
- 2.System Description
- 2.1About This Manual
- 2.2Introduction
- 2.3System Features
- 2.4Physical Description
- 2.5System Description
- 2.6Consecutive Point Architecture
- 2.72 + 0 (East-West) Configuration
- 2.8Spanning Tree Protocol (STP)
- 2.91+1 Protection
- 2.101 + 1 Multi-hop Repeater Configuration
- 2.11Data Interfaces
- 2.12Crosspoint Switch
- 2.13Power Management
- 2.14Event-HD Software and Network Management
- 2.15System Loopbacks
- 3.Installation
- 3.1Unpacking
- 3.2Notices
- 3.3PRE-INSTALLATION NOTES
- 3.4Back-to-Back Bench Testing
- 3.5Overview of Installation and Testing Process
- 3.6Site Evaluation
- 3.7Installation of the Event-HD
- 3.8Quick Start Guide
- 3.9SDIDU™ Service
- 4.Summary Specification
- 5.Rear Panel Connectors
- 5.1DC Input (Power) Connector
- 5.2Ethernet 100BaseTX Payload Connector 1-2
- 5.3SONET Payload Connector
- 5.4STM-1 Payload Connector
- 5.5DVB/ASI, DS-3, E-3, STS-1 Payload Connector
- 5.6NMS 10/100BaseTX Connector 1-2
- 5.7Alarm/Serial Port Connector
- 5.8ODU Connector
- 5.9T1/E1 - Channels 1-2 Connector
- 5.10T1/E1 - Channels 3-16 Connector
- 5.11USB
- 5.12Voice Order Wire
- 5.13Data Order Wire
- 6.Appendix
3. Installation 3
ODU 1 ODU 2
SDIDU 1 SDIDU 2
30dB 30dB20dB
10W 2W 10W
Ant.
Port
Ant.
Port
TNC IF
Cable
(supplied)
TNC IF
Cable
(supplied)
Figure 3-2. Event-HD Back-to-Back Testing Configuration
3.5Overview of Installation and Testing Process
The installation and testing process is accomplished by performing a series of separate,
yet interrelated, procedures, each of which is required for the successful implementation
of a production Event-HD network. These procedures are as follows:
• Site Evaluation: gathering specific information about potential Event-HD radio™
installation sites.
• Cable and Installation: Testing and installing ODU cables and optional interface
devices at installation sites.
• Event-HD ODU Mounting and Alignment: Mounting ODUs to a pole or wall, performing
link alignment and radio frequency (RF) verification.
• Event-HD Digital Radio Configuration: Using Event-HD Link Manager software to
install network- and site-specific parameters in the radios.
• Event-HD Digital Radio Testing: Performing cable continuity checks and RF tests for
links, the payload/radio overhead channel, and the management channel.
The following diagram shows where installation and commissioning resides within the
Event-HD network deployment life cycle and defines the sequence in which the processes
that comprise installation and commissioning should be performed.
© 2007 Moseley, Inc. All Rights Reserved. 602-14886-01, Rev. A