User's Manual
Table Of Contents
- 1.Safety Precautions
- 2.System Description
- 2.1About This Manual
- 2.2Introduction
- 2.3System Features
- 2.4Physical Description
- 2.5System Description
- 2.6Consecutive Point Architecture
- 2.72 + 0 (East-West) Configuration
- 2.8Spanning Tree Protocol (STP)
- 2.91+1 Protection
- 2.101 + 1 Multi-hop Repeater Configuration
- 2.11Data Interfaces
- 2.12Crosspoint Switch
- 2.13Power Management
- 2.14Event-HD Software and Network Management
- 2.15System Loopbacks
- 3.Installation
- 3.1Unpacking
- 3.2Notices
- 3.3PRE-INSTALLATION NOTES
- 3.4Back-to-Back Bench Testing
- 3.5Overview of Installation and Testing Process
- 3.6Site Evaluation
- 3.7Installation of the Event-HD
- 3.8Quick Start Guide
- 3.9SDIDU™ Service
- 4.Summary Specification
- 5.Rear Panel Connectors
- 5.1DC Input (Power) Connector
- 5.2Ethernet 100BaseTX Payload Connector 1-2
- 5.3SONET Payload Connector
- 5.4STM-1 Payload Connector
- 5.5DVB/ASI, DS-3, E-3, STS-1 Payload Connector
- 5.6NMS 10/100BaseTX Connector 1-2
- 5.7Alarm/Serial Port Connector
- 5.8ODU Connector
- 5.9T1/E1 - Channels 1-2 Connector
- 5.10T1/E1 - Channels 3-16 Connector
- 5.11USB
- 5.12Voice Order Wire
- 5.13Data Order Wire
- 6.Appendix
3. Installation 19
3.7.2.1 Installing ODU2200, ODU6500, ODU7200
11. The ODUxx00 chassis family has mounting holes located on the underside of the
unit. There are total of 10 threaded ¼-20 holes available for mounting directly to a
plate or to a pole with optional pole mounting hardware. The threaded screw locations
are shown below in red in Figure 3-9. It is recommended to use at least 4 ¾” screws
with lock washers.
2
Figure 3-9. ¼-20 threaded mounting hole locations on ODU2200.
Use any 4.
32. For pole mounting, optional brackets are installed in the location as shown below
in Figure 3-10.
4
Figure 3-10. Pole Mounting Brackets on ODU2200
53. Install U-bolts to ODU brackets and tighten. Assembled pole-mounted ODU2200
is shown in Figure 3-11.
© 2007 Moseley, Inc. All Rights Reserved. 602-14886-01, Rev. A