User's Manual

Table Of Contents

3. Installation 29

3.8.5.3 Configuring the Site Attributes

Use the GUI to enter device information as follows:

1. In the navigation menu, select Administration, then Device Information, and then

Device Names.

2. Enter the Owner, Contact, Description, and Location. These values are not

required for operation, but will help keep a system organized.

3.8.5.4 Power on Reset to Factory Defaults

The SDIDU™ may be reset to factory defaults during power up. A power on reset affects

the IP address and the user logins/passwords. To perform a power on reset:

1. Power on the SDIDU™

2. During bootup, the SDIDU™ will flash the controller-card LED alternating

red/green for five seconds.

3. Make sure the call button is not active at the start of this five second period.

4. While the LED is flashing, press the call button and release it within one second of

the LED changing to static green.

3.8.5.5 CLI Access via NMS Ethernet

The CLI may be accessed via NMS Ethernet after connecting and configuring the PC as

described in the previous section. Then using a Telnet client, telnet to the SDIDU

address. You will be prompted for a username and password. Use the username and

password supplied at the end of this guide.

3.8.5.5.1CLI Access via Serial Port

The CLI for configuring/monitoring the SDIDU

may be accessed via the front-panel

serial port. Table 3-3 shows the pinout for constructing a DB-9 to HD-15 cable.

Table 3-3: Serial Cable Pinout

DB-9 Pin HDB-15 Pin

2 2

3 3

5 5

The serial port parameters are show in Table 3-4.