PART NO. 1440-400/REV. D MOSQUITO MAGNET Liberty OPERATION MANUAL Your trap will begin capturing immediately, but allow 4-6 weeks to interrupt the breeding cycle. US Patents: No. 6,145,243, No. 6,286,249 AU Patent No. 726575, NZ Patent No.
NOTICE: PLEASE READ THE ENTIRE MANUAL BEFORE ASSEMBLING AND STARTING UP YOUR MOSQUITO MAGNET LIBERTY. MOSQUITO MAGNET Liberty TABLE OF CONTENTS Safety…………………………..……...........................................2-4 Parts included……………………...........................................……5 Tools needed……….………………............................................…5 Hardware included………………...........................................……6 Assembly instructions………………..........................................
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. CAUTION: The gas pressure regulator provided with this appliance must be used. This regulator is set for an outlet pressure of 11.0 in. Water Column. The gas supply must be turned off at the LP-Gas supply cylinder when this appliance is not in use.
PARTS INCLUDED HARDWARE INCLUDED WHEELS: FOR STEPS 3-5 (2) (2) (2) (2) A1 (1) Self-contained Liberty powerhead (1) Adaptor NOTE: All parts are shown at actual size. Use the graphics to match up the corresponding part, or use the ruler provided below.
ASSEMBLY INSTRUCTIONS IMPORTANT NOTES: ASSEMBLY INSTRUCTIONS 1 8 9 10 L 1. Your trap will begin capturing immediately, but allow 4-6 weeks with trap running 24 hours/day to interrupt the breeding cycle. 2 R HOLE B HOLE A 2. DO NOT MOVE MOSQUITO MAGNET WITH TANK ATTACHED. DISCONNECT TANK FROM REGULATOR BEFORE RELOCATING TRAP TO AVOID DAMAGE TO REGULATOR OR TRAP. Take base frame and lay upside down on a raised flat surface (i.e. table).
ASSEMBLY/STARTING INSTRUCTIONS ASSEMBLY/STARTING INSTRUCTIONS 17 18 19 26 27 Peel cover from attractant cartridge. Using a coin, unscrew cover from attractant compartment inside of CO2 tube. Slide attractant cartridge into compartment. Recap and secure tightly. Unlatch net door by turning clockwise. Place standard 20 lb. propane tank (not included) into round cradle hole in base. Clip tether from bottom of Liberty around tank handle.
FOR BEST RESULTS STARTING INSTRUCTIONS 1 Install additional attractant in designated compartment. (#18) 1 Your trap will begin capturing immediately, but allow 4-6 weeks with trap running 24 hours/day to significantly reduce the biting insect population and interrupt breeding cycle. 2 Install Net - You will hear a snap when bag is secure. (#20-23) 2 Should you experience an interruption of power, be sure to restart the trap. 3 Close and turn latch on net door. Be sure net door is closed securely.
GAS RESET TOOL INSTRUCTIONS If your Mosquito Magnet fails to start, it may be the result of poor gas flow from the propane tank through the regulator to the trap. The attached tool has been designed to reset the internal mechanisms of the propane regulator and release any back pressure from your tank. Please follow these steps: TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSES SOLUTIONS Unit won’t start 1) Is Propane tank empty? 1) Weigh tank and check against “empty” weight written on tank.
PRODUCT REGISTRATION BURYING THE POWER CORD Mail completed form today or register on-line at www.mosquitomagnet.com First Name Last Name Address City State/Province DETACH HERE BEFORE MAILING Use the Cord Burying Clips supplied. Place clips approximately 5’ apart, tap into ground with a hammer making sue not to damage power cord. Make sure unit is unplugged and in proper position. For alternate placement follow steps illustrated below.
