Manual

Do not load shotgun until ready for use! Unload shotgun when shooting
has been completed! The safety button should always be in the “ON”
(
SAFE) position whether the firearm is loaded or not.
Check to be certain that the ammunition selected is the same type of
cartridge as designated on the left side of the barrel.
The magazine capacity is two (2) rounds. Put one shell at a time into the magazine,
brass-end rearward. Depress each shell down into the magazine and fully rearward,
under the feed lips. With the shotgun safety still “on” and the bolt still open, slide
the magazine through the stock using the angle bar for alignment. Push the maga-
zine as far as it will go into the cavity–then give it a final tap to ‘snap’ the magazine
into position.
Three-round capacity is achieved by depressing the first two shells into the maga-
zine and placing the additional shell into the chamber. Depress the exposed shell in
the magazine, allowing clearance over the shell while closing the bolt.
FIRING
Discharging firearms in poorly ventilated areas, cleaning firearms, or
handling ammunition may result in exposure to lead and other
substances known to cause birth defects, reproductive harm, and other
serious physical injury. Have adequate ventilation at all times. Wash
hands thoroughly after exposure.
With the shotgun pointed in a safe direction and held in the proper firing position,
move the safety right to its “OFF” (FIRE) position. Pulling trigger through its full trav-
el to the rear, will fire the gun.
Should the shotshell fail to fire, keep the gun pointed in a safe direction.
Rotate the safety cap fully to the left to the “ON” (SAFE) position. Remove
the misfired shotshell and segregate from other ammunition. Do not
attempt to refire a misfired round.
If at any time during firing, the report of any given round is noticeably loud-
er or softer than previous rounds fired, STOP! Do not load or fire additional
rounds until you have put safety in the “ON” (SAFE) position, then safely
unload your firearm and inspect it for possible damage or obstruction in the
chamber or bore.
After the shotgun is fired, raise the bolt handle and pull back as far as it will go. This
motion will eject the spent casing.
To feed the next shotshell, push the bolt lever fully forward, then down. The shotgun
is again ready to fire.
Each brand and type of ammunition can produce different accuracy results in each
barrel. It is best to try as many types and brands of ammunition as possible to
determine which performs best in your shotgun.
TO UNLOAD
Rotate the safety cap fully to the left (counter
clockwise) to the “ON” (SAFE)
position (Fig. 1). During unloading, never allow fingers or any other object
to contact the trigger. Keep the muzzle pointed in a safe direction at all
times.
Raise the bolt handle and pull back as far as it will go. This motion will extract and
eject a live, or spent shell from the chamber. Immediately verify that the barrel
chamber is empty
. Leave the bolt open, r
emove the magazine fr
om the shotgun
then lift out all live shells from the magazine.
4
66624 3/2/09 11:53 AM Page 4