User Manual
3
BARREL ASSEMBLY
CAUTION: Never close the action or pull trigger while barrel is removed as damage
could result to the rearm.
To facilitate shipping, some models are packaged with the barrel removed. To install the
barrel in the receiver, proceed as follows:
Visually inspect the inside of the barrel to make certain it is free of any
obstructions, excessive oil or grease before installation. If you are unable to
remove all obstructions, bring the shotgun to a qualied gunsmith or ship it to the
authorized Product Service Center. Obstructions of any kind may result in
rearm damage and/or serious personal injury to the shooter and those nearby if
the shotgun is red.
Move the safety button, fully to the right, to the “ON” (SAFE) position (Fig. 2).
All Models: Depress the action lock lever (Fig. 3) and move the forearm rearward until
the front of the bolt is in the middle of the ejection port (Fig. 7).
88™ Models: Slide the barrel into the receiver and tighten the takedown screw, nger
tight only. DO NOT use pliers or a wrench to tighten the takedown screw. A little space
between the magazine tube and the takedown mount is normal (Fig. 4).
91™ Models: Unscrew the magazine/barrel cap by turning it counterclockwise.
The magazine spring exerts pressure on the retainer, use caution when
assembling or disassembling.
Slide the barrel takedown mount ring over the magazine tube while guiding the barrel
extension portion of the barrel into the receiver (Fig. 4).
Gently rotate the barrel back and forth while pushing the barrel into the receiver.
Tighten the magazine cap, nger tight only. DO NOT use pliers or a wrench to tighten
magazine cap.
88 and 91 Models: Check to be certain that the barrel is fully seated into the
receiver by looking through the ejection port.The barrel extension must rest rmly
against the corresponding cut in the top of the receiver as shown in Figure 4.
NOTE: During ring, the action unlocks automatically after the hammer falls and
the action can be cycled without depressing the action lock lever.
66626.indd 5 3/10/09 1:32:24 PM